[Elecraft] Transverter question

[Don Brown]

Hi

If the Kenwood has a low level transverter output then you can set up the jumpers for 0 to 1 MW input. Another option would be to build a 50 ohm 3 db power attenuator on the output of the Kenwood. There are several designs in the back of the ARRL handbook. The low level out is the best way to do if the Kenwood has it and I think it does.

Don Brown

KD5NDB


  ----- Original Message ----- 
  From: W9DHI<mailto:w9dhi at ameritech.net> 
  To: elecraft at mailman.qth.net<mailto:elecraft at mailman.qth.net> 
  Sent: Friday, August 20, 2004 11:22 AM
  Subject: [Elecraft] Transverter question


  I'm helping a friend out who bought a 222 transverter from Elecraft but
  wants to use it with his TS850S.  The 850 will only go down to 9 watts and
  the Elecraft wants a max of 8 watts, any help out there???


  Gregg R. Lengling, W9DHI, Retired
  Administrator http://www.milwaukeehdtv.org<http://www.milwaukeehdtv.org/>
  K2/100 S#3075 KX1 S# 57
  Member:  ARRL, RSGB, RCA, WERA and ORC
   




  _______________________________________________
  Elecraft mailing list
  Post to: Elecraft at mailman.qth.net<mailto:Elecraft at mailman.qth.net>
  You must be a subscriber to post to the list.
  Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>    
  Help: http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm>
  Elecraft web page: http://www.elecraft.com<http://www.elecraft.com/>