[Elecraft] using a freq standard for the K1

[Sandy W5TVW]

Only if it has  locked multivibrator circuitry in it to give you precision markers
at 100 Khz intervals.  Better yet 10 and 1 khz intervals.  Usually it is easy to add
a 'divide by 10' circuit externally using a common CMOS chip to get 1 mhz markers.
Add another one after that and get 100 khz markers, which will prove usually
quite adequate.
73,
Sandy W5TVW
----- Original Message ----- 
From: "Lloyd Lachow" <llachow at yahoo.com>
To: "List Elecraft" <elecraft at mailman.qth.net>
Sent: Thursday, August 12, 2004 10:35 AM
Subject: [Elecraft] using a freq standard for the K1


|    I have a frequency standard by W8DIZ that generates
| a signal at 10MHz, 5MHz and 2.5 MHz.  Is there a way
| to use this for accurate calibration of the receiver
| in a 20/40M K1?
|
|    LL
|
|
|
| __________________________________
| Do you Yahoo!?
| Yahoo! Mail - Helps protect you from nasty viruses.
| http://promotions.yahoo.com/new_mail
| _______________________________________________
| Elecraft mailing list
| Post to: Elecraft at mailman.qth.net
| You must be a subscriber to post to the list.
| Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
| Help: http://mailman.qth.net/subscribers.htm
| Elecraft web page: http://www.elecraft.com
|
|