[Elecraft] 80m Recieve

[David N.]

Hello all
K2 #4320
during recieve alignment 80 meters is very low and l3
l4 have now effect on the strength of the signal.
Is this in the low pass filter I did a relay reset 065
but that had no effect I have gone back through the
soldering of each of the components In the low pass
and band pass filter of 80 meters but no avail.
I am a little confused about the latching relay I know
that the stripe across the front indicates pin 1 but
how does the numbering sequence go does it  go 123456
down the row and then 789 etc back up to the top. In
troubleshooting I was going to verify switching of the
low pass filter to try and trace continuity through
the circuit in the event I have a bad solder joint.
Thanks 
David KR4OW
K2#4320 



		
__________________________________
Do you Yahoo!?
Y! Messenger - Communicate in real time. Download now. 
http://messenger.yahoo.com