[Elecraft] diff tx anf rec

[Don Wilhelm]

Rolf,

Is the frequency actually different in LSB or USB mode, or only for CW?  CW
should offset the frequency by the sidetone pitch value.

If your K2 filters and BFOs are aligned properly, you should receive on the
same frequency as the carrier transmit frequency in SSB mode, for CW mode,
the dial display is shifted by the frequency that you have selected for the
sidetone pitch.  -- Note that the BFO for FL1 is always used for transmit,
so if your filters are not all set for the same bandpass-center pitch, you
will create a frequency offset.

If you would like more detail information, check out the K2 Dial Calibration
article on my website www.qsl.net/w3fpr.

73,
Don W3FPR

----- Original Message ----- 
From: "roffe" <090.52309 at telia.com>
To: <elecraft at mailman.qth.net>
Sent: Thursday, August 05, 2004 4:48 PM
Subject: [Elecraft] diff tx anf rec


> Why does my K2 have diffrent tx freq than rec freq ?????
>
> no split fuinction
>
> regards Rolf
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>