[Elecraft] Dead above 40M - New Info

[Bob Nielsen]

That is a normal message which means you are looking at KDSP2 status
and it is using SSB filter 2 with noise reduction off and notch on. 
Tap the display button to cycle between Frequency, KDSP2 status and
voltage/current.

Bob, N7XY

On Wed, Sep 10, 2003 at 04:03:17PM -0400, K8RS wrote:
> Guys,
>          After hooking up my antennas and running through the bands. I see
> that the receive seems to work on 160M, 80M and 40M, but xmit is
> questionable.  Most important, there is a message on the display that reads:
>                   "51 nr .nt"
> The manual indicates that a "51" is a general  problem with the control
> circuits.
>           Before I start disassembly, I would like to know if anyone
> recognizes this display and can point me in the right direction.
>           I have not begun to test the voltages, but have removed the KPA100
> and am looking at the K2 by itself.  I have the KDSP2, KSB2, K160RX, and
> KNB2 still installed.
>                   Roger K8RS
> 
>