[Elecraft] K2 MODs and KPA100 RS232

[Don Wilhelm]

Carl,
I assume that you are referring to the label on Figure 39 showing a "
Jumper, 4" "  which would be the 4 inch jumper wire.  If so, that wire is
already in place on your control board, so you should have to make no
changes to the K2 boards at all - just plug in the KPA100 and go.

Actually all the option manuals should have errata pages with information
like this for the post 3000 serial numbered K2s.

73,
Don W3FPR

----- Original Message ----- 

| On page 51 of the KPA100 manual modifications to the K2 control board
| are discussed.
|
| Am I reading this right . . .?
|
| My K2, SN 3777, Control board rev B, without the KI02 option, requires
| ONLY the addition of jumper 4 to support RS232 operation.
|