[Elecraft] K1-4 question

[Jessie Oberreuter]

     What is the state of R36 (it's right next to the antenna connector)?
I think one of the mods may be to make it switchable.  It needs to be
in-circuit for the K1's meter to work if the ATU is not installed.  If the
ATU /is/ installed, the resistor should be out of the circuit so the meter
will be driven from the ATU's rf sense circuits.


On Tue, 14 Oct 2003, David J Adams wrote:

> Greetings!  Quick question.  I just did a trim cap replacement and the
> K-1 upgrade (not the VFO linearity, but the two dipswitches and
> inductor).  I tuned the four band board and everything seems to be hunky
> dunky, except that the K1 insists that the power output (into a dummy
> load) is zero (all bands).  Every receiver in my house seems to disagree
> as I can swamp them.  Unfortunately, my Bird HF slug has gone AOL, so I
> have no wattmeter to verify output.  If we assume that the power out is
> actually non-zero, any thoughts on what I might have damaged during the
> upgrade to cause the lack of power reading on the k-1 display?
>
> 73 de dave, n9uxu
>
> _______________________________________________
> Elecraft mailing list: Elecraft@mailman.qth.net
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
> Also see: http://www.elecraft.com/elecraft_list_guidelines.htm
>