[Elecraft] KIO2 - Control Board Mod?

[Don Wilhelm]

Brian,
If you have a 'longish' wire (about 3 inches) soldered onto the back of the
control board, there is a very strong likelyhood that you already installed
the mod.
The A to B instructions do not specify the wiring for this mod, but refers
to the KPA100 or KIO2 instructions.  See the last part of page 10 in  the
"Upgrading the Elecraft K2 to Revision B" manual - the section titled
'RS-232 and Sidetone Source (KIO2/KPA100)'

73,
Don W3FPR

----- Original Message ----- 
|
| Hi all:  I am building the KIO2 Aux I/O Module for my K2.  There is a
| set of steps
| >that involves modifications to a Rev A Control Board, but are not
| needed
| For a Rev B Control Board.
| >
| >I have already done all the A to B Upgrade mods for the K2, including
| those
| >for the Control Board.  Can I assume that I can skip all the mod steps
| for
| >the Control Board that the KIO2 kit requires?  Or are these in addition
| to
| >the A to B upgrade mods already completed?
| >