[Elecraft] problems with topband

Thu Oct 9 10:59:01 2003

In addition to following Tom, N0SS, troubleshooting email, I would
suggest you check the VCO voltage which could be out of range. Mine was
on the low side and I had to add some capacitance. 

This can be found in the Unoffical K2 Mods page
http://www.qsl.net/la3za/K2/mod.html under 1. General mods and press
K160RX. There are two links there for either too high or too low VCO
voltage in the 160 meter band.

Good luck!

--
73, 
Sverre

------------------
Sverre Holm, LA3ZA
www.qsl.net/la3za

> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]] On Behalf Of John.s.Griffin
> Sent: 9. oktober 2003 14:12
> To: [email protected]
> Subject: [Elecraft] problems with topband
> 
> 
> Hi All, I don't seem to have any receive on topband, The 
> r'ant is off, and the aatu is tuning SWR 1.0.1 with the ant 
> attached, With the r'ant on I can hear a signal but it 
> doesn't disappear when moving the vfo almost as if the vfo is 
> locked, But it isn't, Signals that are strong on my FT897 
> cannot be heard on the K2, help!!!!! Also how do you set the 
> clock it's a couple of minuets slow, I didn't build the radio 
> but I have all the manuals for the options that are fitted, = 
> KSB2 SSB,KNB2, K160RX With receive ant switch, KAF2, KAT2 
> A.A.T.U, The Firmware is 2.01H 1.02  And Serial No is 00791, 
> TIA, John, M0CDL..
> 
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see: 
> http://mailman.qth.net/mailman/listinfo/elecra> ft
> Elecraft Web 
> Page: http://www.elecraft.com
> Also see: 
> http://www.elecraft.com/elecraft_list_guidelines.htm
> 
> 