[Elecraft] 160 Meter Alignment Question

[Paul Clay]

Duh, never mind.  I just read the errata page for 
the 160 meter module manual (which I HAD read at 
one time and then, apparently, forgot) that 
indicates that for my post-serial 2000 K2, the 
VFO linearization step is unncessary (done only 
once and on 40 meters).

Sorry, folks.

- Paul, N6LQ



On Thursday 02 October 2003 17:13, Paul Clay 
wrote:
> Just installed my K160RX module and everything 
was 
> going great (able to call up 160 meters on the 
> VFO dial, 2nd receive antenna works FB) up til 
> the 160 meter alignment step.
> 
> After setting the VFO for 1800.10 khz, and 
> connecting the frequency counter probe, and 
> selecting CAL PLL to initiate 160 meter VFO 
> linearization, I get an INFO 232 error message.
> 
> According to the K2 MANUAL, INFO 232 tells one 
> that they have tried to linearize the VFO 
without 
> first selecting 40 meters.
> 
> Any idea what might be causing my INFO 232 
> message?
> 
> -- Paul, N6LQ
> 
> 
> _______________________________________________
> Elecraft mailing list: Elecraft@mailman.qth.net
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see: 
http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
> Also see: 
http://www.elecraft.com/elecraft_list_guidelines.htm
>