[Elecraft] K2 SSB Module Help

[Eric Swartz WA6HHQ - Elecraft]

No problem Terry. Have fun!
73, Eric

Terry Schieler wrote:
> Bingo!  The little envelope that came with the MH-2 still has the 5.6K bias
> resistor safely tucked away in it.  I knew it was something easy. 
> Thanks Eric! 
> Terry, W�FM
> 
> -----Original Message-----
> From:	Eric Swartz WA6HHQ - Elecraft [mailto:eric@elecraft.com]
> Make sure you have installed the 5.6K bias resistor between pins 1 and 6 of
> the rear of the K2's mic connector as instructed in the MH-2 manual. This
> provides the 5V bias for the MH-2 condenser element.

> Terry Schieler wrote: 
>>I am using the MH-1 Elecraft mic with all the jumpers properly
>>installed on the front panel board.  CW still transmits fine, but 5W into
> adummy load on SSB does nothing and produces no sound on a nearby receiver
>>when modulated.  SSB receive seems fine.