[Elecraft] KX1 Electrolytic capacitor value problem

Sun Nov 16 15:28:01 2003

OK, I believe I see the problem.

My hard copy manual is Rev A, October 2003.

The manual on the Elecraft website- Rev B, November 2003 shows the C35 value
as follows, which matches my remaining component correctly-

Install the following electrolytic capacitors using the same

procedure:

_ C23 (100 �F, 10 V) about 3/4� (1.9 cm) above C53.

_ C20 (10 �F, 35 V) above C23.

_ C35 (100 �F, 10 V) next to C50 above the upper right corner

of the 3-digit display.

I want to thank myself for answering my own question. <G>

Jay  N5ACM

----- Original Message ----- 
From: "Jay Blass" <[email protected]>
To: <[email protected]>
Sent: Sunday, November 16, 2003 2:08 PM
Subject: [Elecraft] KX1 Electrolytic capacitor value problem

OK, Page 35 on the KX1 manual, second installation paragraph-

C35 calls for a 100mF 35V electrolytic capacitor. I have one left, it is
a100mF 10V capacitor.

All other installed capacitors match the manual specs.

The inventory sheet on pg A2 shows that both C23 and C35 shold be Capacitor,
100mF electrolytic, low profile but doesn't show a voltage.

Is this a typo or do I need a 100mF, 35V capacitor for C35?

Nothing on the errata sheet about this...

Any advice would be appreciated.

Jay N5ACM

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
_______________________________________________
Elecraft mailing list: [email protected]
You must be subscribed to post to the list.
To subscribe or unsubscribe see:
http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com
Also see: http://www.elecraft.com/elecraft_list_guidelines.htm