[Elecraft] 4MHz calibration

[E.G. Bixby]

REF: K2, #03838, Alignment test part II.

When I plug in the frequency counter to P6 & TP3 then activate CAL FCTR 
I should get 12090kHz - my reading =0.0.  But my frequency counter reads 
OK both at TP3 and through the Elecraft rf probe.  Everything is w/n 
tolerances in the trouble shooting section (reference oscillator; VCO 
output and VCO buffer are all OK). 

The 4MHz oscillator on the control board  (left pin of C22) should read 
4K but reads 0.  C22 is all over the board on my frequency counter. 

Any idea what to try next?

Thanks in advance
WB7SBD de ed