[Elecraft] K2 INFO 232?

[Don Wilhelm]

Deni,
INFO 232 says that the K2 microprocessor *thinks* the counter probe is not
attached to TP1.
If you really had the probe attached there, check the probe first by seeing
if you get a proper indication of the VFO frequency by using CAL FCTR - if
not good, plug into TP2 and see if OK.  If the probe gives a good indication
in one or both test points - the probe is OK.
Next check out the soldering in the area of the VFO and the actual
connection to the test probe socket.  Check soldering again and then check
for the component values.

Somewhere along the way, you should find the problem.

73,
Don W3FPR

----- Original Message -----

> Hi I've just completed the At to B upgrade of my K2 1188.
> All checks out ok UNTIL the VFO linearization routine, 40M TP1 where it
> reports INFO 232.
> Any suggestions where to start looking for this problem appreciated.
>
> PLL ref oscillator range test is fine.
>