[Elecraft] K1 Receiver OPF Calibration

[Martin.Evans@simoncarves.com]

Hi everyone, didn't get a reply on this last time so here it is again.

When doing the K1 receiver alignment, I noticed a ref to an internally
generated signal (K1 manual p41 under operating freq calibration). I think
there is a birdie off the lower band edge is this what is being referred
to, if so where does it come from, is it accurate and should I use it? I
used a xtal calibrator to do the alignment but would be interested in some
other method that was maybe more accurate. I don't have another tx or even
rx to use.

Thanks for the help guys. BTW This reflector is a real help for beginners
like me, keep up the good work.

Martin
M0KWV
K1 #1534

PS Thanks Dave for the advice on CW operating, I will stick with my
straight Kent key in the right hand for now.



Why not take a look at our Web site?
http://www.simoncarves.com

*************************************************************************
The information in this email and any attachments may contain
privileged and/or confidential information intended solely for
the use of the individual or entity to whom it is addressed.
If the reader of this email is not the intended addressee, or the
employee or agent responsible to deliver it to the addressee,
you are hereby notified that any dissemination, distribution or
copying of this communication is strictly prohibited.
If you have received this communication in error, please notify
me by telephone or email and delete all copies immediately.
*************************************************************************