[Elecraft] K2 Temp. compensated PLL mod

[Eric Swartz WA6HHQ - Elecraft]

I would start with the recommended 3.7 xtal settings and then adjust them to 
your liking. They are only an approximate starting point, especially for TX 
audio settings with BF1t.

73, Eric


Phil Wheeler wrote:
>
> Welcome back, Eric.
> 
> I did the 14 xtal mod, the BFO mod and the PLL stability (thermistor) 
> mod.  I did record the BFO freqs before I started.  But when done, I 
> used the BFO settings recommended for the 3.7 (written on the envelope) 
> xtals in the SSB module instructions.
> 
> Was I correct in assuming that with new xtals this would be the best 
> course vs. going back to the old settings?
> 
> 73, Phil
> 
> p.s. -- Will do a Spectrogram adjustment as soon as I build the noise 
> generator kit.
> 
>