[Elecraft] K2 Resistor Tolerance

[N2EY@aol.com]

In a message dated 5/17/03 7:29:33 AM Eastern Daylight Time, 
bill@bofc.fsnet.co.uk writes:


> Control board - R8, 100, 1%. Multimeter gives a reading of 102.4 which is 
> over 2%. Is this okay?
> 
> 

I'm pretty sure it's OK, but consider this question:

What's the tolerance of your multimeter? The fact that something reads out to 
four or five decimal places doesn't make it spot-on accurate to that many 
places.

73 de Jim, N2EY


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---