[Elecraft] How do I config the K2 to put out RF on the original BNC connector?

[Roland]

Hi,

After visit the site of KE1L  I have some questions about resistor R88 on
the rf-board.
For KNB2 I had to put in a resistor at R88 of a value of 2K7. R89 were
jumper and R90 removed.

When I put a resistor of 470 at module pins 5&6 it will be parallel with R88
on RF-board.
So, after calculating (1/Rtot=1/R1+1/R2) it shows that 570 will be a better
value... but, in the E12 you use 560 plus 10 ohm serial ofcourse.

Is this all right or doesn't it matter?

>> Try Ke1l's site for the 'unmodules':
>> http://mail.buttery.org/mark/unmodule/

73, Roland
PE1PHU
---
K2#3195