[Elecraft] Info 232 ?

Sun May 4 00:47:03 2003

David

Thanks for the quick response ... but, sadly, it didn't work.  Still gets
INFO 232.

Too bad, since I just put in the new firmware before I added the Temp-Comp
mod, and it worked fine after I plugged in the new chips and re-set the
filter settings.

It's very late here and I have to get up very early... time to call it a
night.

In my semi-exhausted state, I already blundered and plugged in the 12v to
the AUXRF port, and, dumb me, I never got around to installing that blocking
cap.  I'm fairly certain I fried K12.  So, I have two problems to fix now
instead of just one.

I'll watch for other messages regarding my lack of 12 MHz on TP1 tomorrow.

Thanks again es 73

Steve KZ1X/4
K2 #771

----- Original Message -----
From: David Gropper <[email protected]>
To: Steve Jackson <[email protected]>; <[email protected]>
Sent: Saturday, May 03, 2003 23:44 PM
Subject: Re: [Elecraft] Info 232 ?

> Steve,
>
> Try it on 7.1 Mhz
>
> Dave KK7SS
> K2 #3003
>
> ----- Original Message -----
> From: "Steve Jackson" <[email protected]>
> To: <[email protected]>
> Sent: Saturday, May 03, 2003 8:26 PM
> Subject: [Elecraft] Info 232 ?
>
>
> > I just installed the new temp. compensation mod.  All went
> well.
> >
> > Once I got nearly done, I went to the alignment and test
> section on page 3
> > of the instructions.
> >
> > It says to do a CAL PLL.
> >
> > Well, OK.  I connect the internal probe to TP1, and select
> CAL PLL.
> >
> > The display briefly shows me a frequency of about 10.856
> MHz, and then shows
> > INFO 232.
> >
> > Any ideas, before I go fiddling?  BTW, the rig now neither
> receives nor
> > transmits.
> >
> > Steve KZ1X/4
> >
> > _______________________________________________
> > Elecraft mailing list: [email protected]
> > You must be a list member to post to the list.
> > Postings must be plain text (no HTML or attachments).
> > See: http://mailman.qth.net/mailman/listinfo/elecraft
> > Elecraft Web Page: http://www.elecraft.com
>