[Elecraft] [K2] RIT question

Mon Mar 10 09:16:01 2003

Hi

The center can be adjusted by moving the knob on the shaft but 1/4 turn is
way off. The center should not be that far off. Check the other pots to see
if they work normally. The same MPU input is used for all of the pots except
the AF and RF gain. If the other pots work then look at D6, R14 or the pot.
Be sure you didn't mix up the RIT pot with the AF gain pot. The AF gain is
different from the other pots.

Don Brown
KD5NDB

----- Original Message -----
From: "Jibeji" <[email protected]>
To: "Elecraft" <[email protected]>
Sent: Monday, March 10, 2003 2:29 AM
Subject: [Elecraft] [K2] RIT question

> Hello.
> I have finished to build my K2 #3249.
> Except of 12 meters band, which still doesn't work, all work perfectly.
> However, I have a question about the RIT function.
> When I place the RIT potentiometer in its middle position (0) and I push
RIT
> button  I have an offset of about -500 Hz. So, to have the same reveicer
> frequency with or without RIT, the potentiometer has to be turned CW of
> about 1/4 turn.
> Is the center position settable ?
> Thanks, 73
> --
> F8DQL
> UFT 1116
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>