[Elecraft] Re: KPA100 shield kit tip

[Gary L Surrency]

I found a small wire brush chucked in a hand drill worked very well.

If you install and remove the KPA100 a few times with the PA shield clips
installed, it will leave scratches on the inside of the L and R chassis
panels so you'll know where to clean off the paint.


Gary Surrency AB7MY

On Fri, 20 Jun 2003 09:18:58 -0700 Wayne Burdick <n6kr@elecraft.com>
writes:
> One of many methods that will work. Thanks, Philip.
> 
> Another tip: Use the point of an exacto knife blade to scrap the 
> paint away. I
> tried this recently and it worked so much better than sanding that 
> I'm planning
> to revise the instructions.
> 
> 73,
> Wayne
> 
> 
<snip>

________________________________________________________________
The best thing to hit the internet in years - Juno SpeedBand!
Surf the web up to FIVE TIMES FASTER!
Only $14.95/ month - visit www.juno.com to sign up today!