[Elecraft] Supply voltage and diode drops....

Wed Jun 18 11:13:00 2003

In-Reply-To: <[email protected]>
Yeah, that makes sense, Harry.  Although I suppose one could argue that 
since you need to change a jumper on the control board (P7) to enable the 
voltmeter, you may as well change a menu option to disable the automatic 
addition of 0.65 to the voltmeter at the same time.  If there was a spare 
input on the PIC, this could be done automatically with a few more parts.

Cheers,
Dave GW0LUA

-------------------

> From: Harry Yingst <[email protected]>
> Subject: Re: [Elecraft] Re: Elecraft digest, Vol 4 #205 - 42 msgs
> Because then the volt meter would be off and no good for other purposes
> unless you subtracted that fixed ammount from the reading.
> it is far easier the way it is