[Elecraft] Some reassurance needed please.

[John R. Lonigro]

Ed:

I had the same results (and same worries) with my DVM, but #3401 works 
fine.  I think I read somewhere that you sometimes get readings closer 
to what the manual says using an analog ohmmeter.  Maybe the 
instructions were written to allow for that possibility.

Hard to tell without looking if your soldering is adequate, but if the 
hole is filled, it sounds OK to me.

73's and good luck,

John AA0VE

Kenworthy, Edward (EDS) wrote:

>Secondly, checking the resistance, I note all the resistances are OK, so
>where it gives a range my readings are within the given range, but with some
>of the others that say >100K (eg the two oscillator pins on the PIC, pins 13
>and 14 I think) my reading is off the scale. Even with my DMM set to 2M
>range the resistance is off the scale. Yes I know "off the scale" is >100K,
>but why say >100K, why not >2M or >20M (if you see what I'm getting at) ?
>
>  
>