[Elecraft] RE: Signal generator for K2 alignment & test?

[John R. Lonigro]

>
>
>I've found the MFJ 259 difficult to use as a signal source because of the
>drift.  I have to set it above the radio's frequency and let it drift into
>the receiver's passband.  A short time later, I have to repeat the process,
>since it will have drifted back out.  Its oscillator is fine for its intended
>purpose - antenna analyzing -  but it lacks stability as a quality signal source
>and would be hard to use to peak coils.  I have the original 259.  Perhaps
>the 259B is better in that respect.
>
>
>
>73's
>
>
>
>John AA0VE
>
>I've gotten to Alignment and Test Part II at the end, but I cannot find a
>signal off a long wire antenna.  Also, I get such a weak signal at 7000 kc
>that it's not much use.  I suspect I need a signal generator to go signal
>tracing, but have no idea where to look for such a machine.  Can I use an
>antenna analyzer like the MFJ 259 as an rf source or do I need a different
>piece of equipment?  Any tips as to where to go shopping would be
>appreciated.
>
>73,
>Tom, W6WW
>K2 #3453
>  
>