[Elecraft] Receiver Pre-Alignment

[pfb]

Andy Wallace
Tom Hammond
Bob Tellefsen


Thank you for the response about page 73 in the manual.  I do not think I
was very clear on the issue I have here.  On L3 and L4 and the subsequent
slugs -  If I turn them back out 2-3 turns then the signal and noise will
have a bit of a muffle sound to it where I can tell that it is not the
strongest - so If I  just set it back some (1/4 turn) the signal/noise floor
is clear again but then I can turn it inward for over two turns there is not
one bit of difference in the signal or noise.  - and I am not sure how many
more turns I can go in --- so where in those 2 or three turns do I set these
slugs in the can.  Other than that one point in backing it out where it just
gets muffled and then I turn it back in slightly to get it clear crisp clean
again How do I decide on the spot to pick out of the next 2 or 3 turns where
the noise or signal all sounds the same?  Where do I leave it set in those
2-3 turns?

Paul
K8QT