[Elecraft] MC-50 settings for P1?

Thu Jul 24 09:28:01 2003

I use an MC-50 with my K2.  I set the internal pins and resistor for the 
MC-43 mic per the manual.  Then constructed a short 8pin to 4pin adapter 
cable to interface the MC-50.

ki5gh
K2#3326

>From: "William M. Spaulding, Sr." <[email protected]>
>To: "Elecraft Reflector" <[email protected]>
>Subject: [Elecraft] MC-50 settings for P1?
>Date: Wed, 23 Jul 2003 18:21:32 -0700
>
>Hi, Folks,
>
>I'm just finishing up my SSB board and installing it without a hitch so 
>far.
>
>I haven't found my Kenwood MC-50 yet.  I recently moved, and all boxes
>aren't unpacked.  Does anyone know if it is like an MC-60 for setting up 
>the
>mike connector P1 on the F/P board?  If it is, I'll go ahead and set up P1
>as the Kenwood data says.
>
>On the other hand, I really ought to have a Heil hand mike.......
>
>There's also an instruction in the manual for the SSB board to set "R60" in
>the PA section of the RF board fully counterclockwise.  Is this a vestige 
>of
>times gone by???  Since I don't have an R60 pot, I guess I'll ignore it.
>
>Thanks,
>
>Bill
>NA7Y
>
>_______________________________________________
>Elecraft mailing list: [email protected]
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com

_________________________________________________________________
STOP MORE SPAM with the new MSN 8 and get 2 months FREE*  
http://join.msn.com/?page=features/junkmail