[Elecraft] High Current On TX

[Rich Lentz]

Mike:

I found that I had to loosen all of the 2-D connectors on the main RF =
board
and the cabinet, get the heatsink properly aligned including the two =
screws,
retighten all of the screws on the main board, then the ones on the case
sides, etc.   Don't think bending the transistor will help as the =
heatsink
screws go though the main rf board.

Rich

KE0X

_______________

An additional problem was that the holes in the heatsink did not quite =
line
up correctly, and I was unable to put in both of the screws holding the
heatsink to the K2 RF board mounting block that is located right near =
the
finals.=20