[Elecraft] Elecraft] Serial 3000+ K2: AGC threshold setting
Donnie Garrett
[email protected]
Wed Jan 22 17:21:00 2003
Andy:
I'm also building a K2 SN# 3186. I just finished the testing found on =
page 46 in the K2 manual. I also ran into the exact same problem! I =
could only get the AGC threshold to 3.8V before running out of =
adjustment on R1. Keep me posted as to what you find out. I would =
certainly like to know. Everything else checked just fine. Im ready =
for Assembly, Part II page 47
=
Donnie Garrett / WA9TGT
----- Original Message -----
From: "Wallace, Andy" <[email protected]>
To: "'Elecraft'" <[email protected]>
Sent: Wednesday, January 22, 2003 11:30 AM
Subject: [Elecraft] Serial 3000+ K2: AGC threshold setting
> Hi, Folks. Quick question to the K2 3000+ owners:
> Did you have trouble setting the AGC threshold? This
> was done with R1 on the Control Board, measuring at
> U2 pin 5. Manual recommends 3.9V. I could only get
> mine to 3.8V and that was with R1 fully counter-clockwise
> as viewed facing the pot. Did so with RF gain fully
> clockwise. 8A regulated line is 7.99V on my meter.
> Leaving it at 3.8, I was able to do the S meter calibration
> for zero and full-scale ok.
>
> Circuit is pretty simple -- RP6 is pretty much it! -- so
> I am wondering what is up. I checked my work and all seems
> OK, but will scrutinize more when I can get back to it.
>
> Andy
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
--- StripMime Report -- processed MIME parts ---
multipart/alternative
text/plain (text body -- kept)
text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed. To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html ---