[Elecraft] KAT100 ATU Builder Alert: Anti-Slide Bracket installation

[Wayne Burdick]

Duane, K7ZH, brought this to our attention:

Figure 20b in the KAT100 manual, which shows Anti-Slide bracket installation, is
incorrect. (See page 29 or 30 depending on your manual revision.) The center
hole (of 3) on the bracket should be positioned over the rear-most hole in the
2-D fastener. This will align the standoffs on the bracket with the feet on the
K2. 

If the brackets are installed as shown in the Figure, the K2 will sit too far
forward when stacked on top of the KAT100.

73,
Wayne
N6KR