[Elecraft] L33 Insulator

[Don Brown]

Hi

Here is a solution to the requirement to insulate the bottom panel and L33.
Remove the green masking tape from the heatsink area on the rear bottom
cover. Now stick it on the front bottom cover centered where L33 is located.
If you have already built your K2 and no longer have the masking tape use
black electrical tape. I was going to use some foam tape but it is too
thick.

Another trick is to not remove the green masking tape on the top rear panel
except for any options you are going to install. That keeps the option holes
covered so dust will not get into the radio and the back panel looks better.
When you install a new option cut out around the holes with an Exacto knife.

Don Brown
KD5NDB