[Elecraft] K2 Front Panel Board - Resistance Measurements ??

[Dean Maples]

Thanks to all that replied. Problem solved - I don't have a problem after
all, just a typo on the manual for K2's about SN 3000.

Thanks,
Dean, K9FTB

----- Original Message -----
From: "Rich Lentz" <ke0zx@cox.net>
To: "'Dean Maples'" <K9FTB@INAME.COM>; "'Bob - AG5Q'" <AG5Q@attbi.com>;
<elecraft@mailman.qth.net>
Sent: Wednesday, January 01, 2003 9:47 PM
Subject: RE: [Elecraft] K2 Front Panel Board - Resistance Measurements ??


> Looking at the schematics for K2(A) and K2(B) and the resistance checks on
> page 27 for both versions you will note that both indicate J1 pin 3 is
> ground (0 ohms).  This is correct for those models less than 3000,
however,
> those above 3000 have the mod that got rid of the scratchy audio, and thus
> there is no ground and should read the same as the other pins of R3 (AF
> POT).
>
> Rich,
>
> KE0X
>
>
>
>