[Elecraft] K2 Front Panel board-LED diffuser confusion??

Fri Feb 21 22:16:01 2003

The spacers are broken from the small PC board that is also used as a =
spacer
fro the switch mounting.

Rich
KE0X

-----Original Message-----
From: [email protected] =
[mailto:[email protected]]
On Behalf Of C T Morton
Sent: Friday, February 21, 2003 8:57 PM
To: Elecraft
Subject: [Elecraft] K2 Front Panel board-LED diffuser confusion??

Hi Guys,
Would appreciate a little help from page 25, bottom left. (Place two =
3/4"
long spacer over the leads of each backlight LED as shown in Fig 5-9.) I
dont see any 3/4" spacers in the parts bag nor can I figure out the =
math,
i.e., how do you use (2) 3/4" spacers on LED leads that are only 1/4" =
long
and still get 1/8" above the board? Any suggestions? Tnx Tom

_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.=20
Postings must be plain text (no HTML or attachments).=20
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com