[Elecraft] K1 RF Board Resistance Checks

[John Pfeifer - KL0WN]

Hello,

I'm in the processing of building my first K1, #1456.  I'm halfway
through the RF Board and am doing the resistance checks on page 29 of
the manual.

In previous resistance checks, when a table has some greater-than value
below 100k, I usually get a reading below 100k but above the value
indicated.  In other words, it seems "normal" *NOT* to get an infinite
(or very high) reading when the table says something like > 1 k.  

Would the following readings indicate something is amiss:

TEST POINT    TABLE VALUE    MY MEASUREMENT
P1 pin 16       > 1 k           Infinite
U3 pin 5        > 10 k          19 Meg
U4 pin 6        > 10 k          Infinite
U4 pin 7        > 1 k           Infinite

BTW, I'm using a Radio Shack 22-801 Digital Multimeter.

Thanks,
John Pfeifer - KL0WN
Kodiak, AK