[Elecraft] KPA100 Firmware and tPA setting ?

Mon Feb 10 22:27:10 2003

My firmware is 1.07.  But I can't access tPa via the PA parameters in the
secondary menu, either.  I get at it via the primary menu CAL/edit/CAL
tPa/edit sequence.

----- Original Message -----
From: "Ron D'Eau Claire" <[email protected]>
To: "'Gary Bartlett'" <[email protected]>
Cc: <[email protected]>
Sent: Monday, February 10, 2003 10:09 PM
Subject: RE: [Elecraft] KPA100 Firmware and tPA setting ?

> What version of the firmware are you running, Gary? I don't have that
> option under PA on my K2 with the firmware that came with it last
> November (1.06)
>
> Ron AC7AC
> K2 #1289
>
> -----Original Message-----
>
>
> Phil:
>
>     I accessed tPa via the CAL menu a couple of times after having run
> my rig hard during contests.  The internal temp never exceeded 60 deg C,
> which is well below the threshold of alarm but slightly above a heatsink
> temperature which was comfortable to the touch.
>
> Gary
> VE1RGB
> K2 #2519 (and another one on the way)
>