[Elecraft] KPA100 Firmware and tPA setting ?

Mon Feb 10 20:38:00 2003

Phil:

    I accessed tPa via the CAL menu a couple of times after having run my
rig hard during contests.  The internal temp never exceeded 60 deg C, which
is well below the threshold of alarm but slightly above a heatsink
temperature which was comfortable to the touch.

Gary
VE1RGB
K2 #2519 (and another one on the way)


----- Original Message -----
From: "Phil Wheeler" <[email protected]>
To: <[email protected]>
Cc: <[email protected]>
Sent: Monday, February 10, 2003 9:12 PM
Subject: Re: [Elecraft] KPA100 Firmware and tPA setting ?


> Or maybe it was never there .. or is planned for a later rev.  Has
> anyone used this feature?
>
> 73, Phil
>
> Ron D'Eau Claire wrote:
>
> >Got a follow-up message off-line that this feature had been dropped
> >intentionally!
> >
> >Could this be true??
> >
> >If so why???
> >
> >See what happens when the documentation is not 'up to date' ...
> >questions, questions, questions.... Hi!
> >
> >Ron AC7AC
> >
> >-----Original Message-----
> >
> >I have the same question, so I've been watching for an answer since
> >Saturday...
> >
> >Did I miss it?  I don't find the tPA setting as described in the manual
> >either...
> >
> >Ron AC7AC
> >K2 # 1289
> >
> >-----Original Message-----
> >Hi all,
> >
> >My KPA100 manual shows five possible settings for the PA parameters, one
> >of which - tPA - "allows TUNE mode to display heat sink temperature" My
> >KPA100 has firmware v1.06, but will not display tPA: all I can get is
> >OFF, ON, Fx.xx, and E.
> >
> >Is it me, or is this function not available in v1.06 ?
> >
> >
>
>
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com