[Elecraft] Scan doesn't jump

[W B Reese]

Dear Chuck,

Thanks for being the only one to answer my query!

It's real easy to tell it didn't jump.  You Press Resume and the word Scan 
appears on the display.  After the word Scan disappears, the old frequency 
reappears unchanged from before you hit scan resume.  Not only does the old 
frequency reappear, it stays there forever until the guy stops transmitting 
or fades out.

Sure appreciate the time you spent with me this past weekend!

Thanks! & Very 73,

Tracy WB6TMY
Elecraft #0838

>At 08:33 AM 2/5/2003 -0800, you wrote:
>>I have seen this too. Sometimes, it is difficult to tell if the jump
>>happened when I use Scan Resume, as the word SCAN on the
>>display prevents me from observing what the frequency is doing.
>>
>>Chuck
>>
>> > Dear Fellow Elecrafters,
>> >
>> > I have a K2 that doesn't "jump" a half KHz when I press scan resume on
>> > PF1.  Instead, it just "sits" where it is & locks up the scan.  In
>> > addition, when it stops on a station, it doesn't resume automatically 
>> after
>> > 10-15 seconds.  It will stay on the station until I move the VFO.
>> >
>> > Gary told me that adjusting the S meter might have some effect on 
>> this.  It
>> > is supposed to be adjusted in the CAL FIL sub menu Hi or Lo for one 
>> "S" bar
>> > below the left most bar & one "S" bar below the top most bar.  I've 
>> played
>> > with it up and down from those recommendations, but no joy.
>> >
>> > Can anyone advise me on this?
>> >
>> > Thanks & Very 73,
>> >
>> > Tracy WB6TMY S/N 0838
>> > Elecraft@radions.net
>> >
>
>__________________________
>
>  E-Mail: - Our_Domain@radions.net
>  Tel: - - - - - - - - - - - 707-321-0004
>  Fax: - - - - - - - - - -  707-527-8124