[Elecraft] DEAD K1

[mick]

Info needed ref K1 #01532
Ok after a short time QRT the above unit was powered up to a 12v 5a power
supply when switched on nothing after the covers had been removed i
noticed that ZD D19 36V 1W was flashing over when power was applied.
Ok i will replace D19 but is there any other components that may be
affected, oh polarity of power supply was correct at time of power up.
When D19 has been replaced is there any checks to carry out before power is
applied.

MERRY CHRISTMAS ALL

MICK   M1MGD   GQRP 11355