[Elecraft] Capacitor question for the KX1

John Mahon [email protected]
Sun Dec 28 00:54:00 2003


Aron,
Regarding C45 and C56, I would not pay attention to lead spacing. If your
kit is like mine and the brown disc is larger than the blue disk, use the
larger, brown disc in C45. The small size of the blue cap will be needed for
the C56 installation since there is no dedicated solder pad on the board
(picture on page 34).
My kit had only 4 (270) caps.
I just started mine a few hours ago.
Good luck,
John N2YC
KX1 #336

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Aron Brown
Sent: Sunday, December 28, 2003 12:02 AM
To: [email protected]
Subject: [Elecraft] Capacitor question for the KX1


I am in the process of inventory on all the parts before starting to build.
My question is regarding Caps C45 and C56. One is a blue one and one is a
brown one.(sorry for using Layman terms, it is late and I cannot remember
the names of the caps) The lead spacing does not seem to answer my questions
on this. I also seem to have an extra cap for (270) for C2,4,24 and 25. I
should have 4 and I seem to have 5.
Any suggestions?
Thanks

Aron
NN1F
Bedford, NH
KX1#341


_______________________________________________
Elecraft mailing list: [email protected]
You must be subscribed to post to the list.
To subscribe or unsubscribe see:
http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com
Also see: http://www.elecraft.com/elecraft_list_guidelines.htm