[Elecraft] KAT100-2 help needed

Fri Dec 19 00:28:00 2003

Thanks all for the quick response and I know realize it was my mistake. I
was expecting the chassis to be threaded & didn't realize it was going to
screw into the ground terminal on the PCB. What a relief as I can get this
project finished tomorrow!!!

-rob
----- Original Message ----- 
From: "Phil Verinsky" <[email protected]>
To: "Elecraft" <[email protected]>
Sent: Thursday, December 18, 2003 8:06 PM
Subject: RE: [Elecraft] KAT100-2 help needed

> The thumbscrew screws into a threaded hole in part # E700012 (screw
> terminal, right-angle PCB mount), which is soldered to the PCB, and is
shown
> in the parts list at the bottom of page 5 in my recent manual.
>
> >How does thumbscrew connect to E1ground terminal (pg 23)? Looking at
Figure
> 13 (pg 20).
> >My chassis has a hole in which the thumbscrew slides in/out of E1. What
> keeps it secured to the chassis?
>
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see:
http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
> Also see: http://www.elecraft.com/elecraft_list_guidelines.htm