[Elecraft] Sulfated Lead Acid Batteries

Tue Dec 9 14:17:03 2003

Bill,

a technique I have used is to use a constant current power supply having =
a high compliance voltage. For example a 36 volt power supply with a =
2.5k ohm series resistor and allow this current to flow until the =
battery hits around 14 volts. Then use and charge as before.

   Dave

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of KXBill
Sent: Tuesday, December 09, 2003 9:20 AM
To: [email protected]
Subject: [Elecraft] Sulfated Lead Acid Batteries

Would appreciate any ideas out there on how to restore a sulfated LAB
Cheers=20
BillH_w7kxb_k2-973

_______________________________________________
Elecraft mailing list: [email protected]
You must be subscribed to post to the list.
To subscribe or unsubscribe see: =
http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com
Also see: http://www.elecraft.com/elecraft_list_guidelines.htm