[Elecraft] Panel Knob Replacement Technique Sought

[Phil Wheeler]

Paul Clay wrote:

>Now my question.  I remember from building the K2 
>that it was a bit of a tricky operation to get 
>the small knobs on their pots without damaging 
>the pots.  The manual even warns you to be 
>careful not to damage the pots as I recall, as 
>you do a kind of push in and twist on install  (a 
>couple required a pretty good push).  Any 
>suggestions on how to perform the knob swap out 
>as safely as possible?  Is their a better method 
>than simple reversing the process by which the 
>knobs were installed in the first place?
>

It's been a while, Paul -- but I don't recall any particular problem.  
And I did R&R the knobs a few times.

Phil