[Elecraft] Alignment document for K2 ?

[Don Wilhelm]

Rich and all,

For all of you who have been asking --- I stripped down the K2 manual
leaving only the alignment information.  It is almost the same as the
Elecraft original, but some of the small graphics did not survive the
editing process, but once you have gone through the steps in the manual, I
can't imagine you will have any problems with this document.

You can find it at my website www.qsl.net/w3fpr - look near the bottom of
the index page for the link to the file - it is in .pdf format, so please
right-click on the link and download it rather than viewing it on-line.

I also updated my website article dealing with K2 dial calibration.  You
will now find the N6KR method included (and recommended) for setting the 4
MHz reference oscillator.

73,
Don W3FPR


----- Original Message -----

Is there an alignment document around for the K2?  Something that is trimmed
down so you dont have to go to section 1,2 and 3 of the manual and then to
the SSB manual, etc?

It would just be handy to have a very lean document with this info. Is there
one online that I have missed?

73,

Rich
kd0zv