[Elecraft] Troubleshooting

[Gregg Lengling]

I finally had time to start working on my K2/100 that got hit by
lightning....got the receiver and qrp transmitter working but the AGC
isn't working.

On U1 on the control board you should be able to turn that off/on via
the front panel....I've got a constant full AGC and signal strength
action in either mode.  The output of U1 on pin 4 is 7.6 volts when on
and 7.3 when off...sorta sounds like the NE602 is bad....what you guys
say???


Gregg R. Lengling, W9DHI

Politics is the art of appearing candid and completely open, while
concealing as much as possible.   -States: The Bene Gesserit View