[Elecraft] ksb2 tx/rx alignment

Fri Aug 8 10:20:05 2003

Hi Neil,
Sorry for the late response, just got back from W4 land after two weeks 
of dodging traffic on the I4 !! There are some serious suicide jockeys 
over there :-))

I believe your problem is related to the BFO settings.  If you get these 
wrong, it produces exactly what you describe.  I had a tx/rx offset of 
around 300 Hz also and spent an age checking everything until I re 
adjusted the BFO settings.  Take a look, I think it will solve your 
problem..

73 Trev G3ZYY

In message <000801c352d4$d9566c90$c69f8451@gm0hzi97rkuo66>, neil mclaren 
<[email protected]> writes
>Hi all
>
>i would like to say that #3637 is alive and well     but i cant the tx 
>and rx frequency are off by 300hz and no amount of tweaking has any 
>efect on the problem
>i have done a search on the list (it solved all my other problems) and 
>have seen some posts about the same fault but i cannot find a cure
>
>
>all voltages on rx seem to be correct exept u5-5 6.0v
>                                                               u4-3 6.0v
>
>have not tried tx votages as yet
>
>yours etc neil  gm0hzi
>
>--- StripMime Report -- processed MIME parts ---
>multipart/alternative
>  text/plain (text body -- kept)
>  text/html
>The reason this message is shown is because the post was in HTML
>or had an attachment.  Attachments are not allowed.  To learn how
>to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
>_______________________________________________
>Elecraft mailing list: [email protected]
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com

-- 
Trevor Day