[Elecraft] KAT100 question

Sun Aug 3 22:55:01 2003

Tim:
  Remove the lid the K2 and make sure the RF cable is in good shape and 
well seated in its socket.  If, when you put on the lid, you put the RF 
cable to is connector first, and then worked forward to the I/O cable, it 
is possible you jarred the RF cable loose on its connector, causing 
precisely the problem you are having.  If that doesn't do the job, try 
first loading into a dummy load to see if the problem continues to occur. 
If not, you've got a problem somewhere in the antenna feed, quite 
independent of the K2.  Otherwise, of course, you've got more substantial 
trouble shooting to do.

best wishes,

dave belsley, w1euy

--On Sunday, August 3, 2003 7:15 PM -0700 Tim <[email protected]> wrote:

> Hi folks -
> I've changed nothing (famous last words) but today I started getting a lot
> of "hi refl" messages when I tune my K2/100 - that I did not get before. I
> cannot think of anything I changed - except adding the DSP unit and
> relocating the crystal ground wire (from top to side of crystal) below
> where the DSP installs. Any thoughts as to what might have caused
> this...I've rechecked all menu settings. Thanks for any ideas anyone
> might have. 73/Tim NZ7C
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com

----------------------------------
David A. Belsley
Professor of Economics