[Elecraft] K1 Transmitter Alignment

[John Pfeifer - KL0WN]

Hello all,

Well, everything was going fine until this point...

I finished the RF Board, Part 2 (transmitter) assembly. All the
resistance and voltage checks were good.  Did the preparation for
transmit alignment per page 46 of the manual and set the power to 2.0
watts.

When I begin the alignment and put the K1 into TUNE mode, the display
reads P0.1 and I get no indication of power output on my external
wattmeter, even when the wattmeter range is set to 100mW.

Any suggestions, or is it time to start some signal tracing?

Thanks,
John Pfeifer - KL0WN
Kodiak, Alaska
K1 #1456