[Elecraft] RE K2 12/10 BPF Mod

[k6se@juno.com]

Bill Dumond wrote:

"I'm working on the K2 Modifications for use with the KPA100 and am
getting ready to do the 10/12 meter band pass filter modification. 
There's a note in bold letters that says: "If you have already built your
K2,  be sure to realign the 12m/10m BPF section after you complete this
mod. Well...my K2 is already built. 

Could somone point me to where I go next to do this realignment after I
finish doing this mod. Are there specific procedures to follow? Do you
follow these same procedures for each band.  Page numbers???"
==========
Do the transmitter alignment for 10 and 12 meters only on page 74.

When I did mine, there was little, if any, noticeable difference in the
adjustments from before doing the mod.

73, de Earl, K6SE