[Elecraft] Re: Smoke Generator on KPA100

[Rolf Schröder]

Am Freitag, 4. Oktober 2002 16:29 schrieb Jeremiah J McCarthy:
> If R-10 is cooked, don't you think you should research the area around
> T-5 instead of T-3?
Maybe I wasn't clear enough, it was on the KPA100 were the R10 was fried, it 
is in the circuit of the high voltage bias supply, this is why I was looking 
for T3. 
But now there is something that confuses me a little:
According to page 27 of the KPA 100 manual, The green winding has the "pins" 1 
and 3 and the red winding has the "pins" 2 and 4. According to page 62 of the 
same manual, pins 1 and 2 should be the ends of the same wire as well as 3 
and 4 should be the ends of the same wire. Seems to be a contradiction to 
me... There is no short circuit to ground, as I checked it with my DMM. 
Continuity is there as described in the manual and T3 is wired according to 
the manual on page 27. 

Any feedback is welcome. Well, and I will not hurry because this usually makes 
disasters bigger...
-- 
Best Regards
Mit freundlichen Grüßen
Rolf Schröder

They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety. 
- Benjamin Franklin, 1759 -