[Elecraft] KAT100 - "separate" memories for CW and SSB portions

[Wallace, Andy]

Caveat emptor, as always!!!! I don't even have a K2 yet, but:

I can't find the message where someone wished the KAT100 had
separate memories for two portions of each band, i.e. CW and SSB --
here's an idea. (See the KAT100 manual PDF at Elecraft.)

If you're not using the ANT2 output...

Why not remove the connection for ANT2 from the circuit
board and jumper K18 pins 3 and 4? This would make
the output permanently go to ANT1.

Alternatively, you could pull the relay and clip off the power
pin and reinstall, as it looks like the NC position goes
to ANT1.

Then simply select "ANT2" and tuneup on the SSB portion,
and that would be recalled anytime you selected ANT2.

-Andy