[Elecraft] FT-100 knob
Ron D'Eau Claire
[email protected]
Fri Nov 8 23:00:07 2002
Golly, my stock K2 knob is a plastic shell with a big hunk of brass
inside of it. I don't know how much heavier it could get unless it was
made physically larger too!
Is there more than one kind of "stock" K2 knob out there? Some that
aren't a brass knob with a plastic shell perhaps?
The finger dimple would be nice. I have the tension set so I can roll
the knob along with my finger resting on the face against the little
ridge at the outer edge.
Ron AC7AC
K2 # 1289
Julian, G4ILO wrote:
Yes, if Elecraft made one as an accessory I wouldn't mind paying for a
heavyweight metal knob, just like the current plastic knob but with a
"dimple" in it for tuning. The Yaesu knobs don't look quite right to me.